|
Post by mike on May 12, 2016 8:20:36 GMT -6
Do you know any place that will do such thing ? What we need is someone that will bore the inside of the axle tube to allow a slightly larger RCV axle to be installed in it.
|
|
|
Post by c2 on May 12, 2016 11:02:39 GMT -6
Do you mean ARB locker?
Not sure I follow what you are trying to do??
|
|
|
Post by BEN on May 12, 2016 13:40:24 GMT -6
It's the spindle that needs to be larger
|
|
|
Post by mike on May 12, 2016 15:03:54 GMT -6
Yea found out today it's just the spindle.
I meant RCV.
|
|
Greg
Full Member
Posts: 330
|
Post by Greg on May 12, 2016 19:24:57 GMT -6
If you buy a boring bar we can do it in my mill. I think we could figure it out. Lol
|
|
|
Post by Weezul on May 13, 2016 7:00:17 GMT -6
Yea found out today it's just the spindle. I meant RCV. Stepping up!?
|
|
|
Post by mike on May 13, 2016 10:10:41 GMT -6
Yea found out today it's just the spindle. I meant RCV. Stepping up!? It's not for me it's for slinky. I'm going to get it from spyder soon. Anyone up for helping put the axles in it.
|
|
|
Post by mike on May 13, 2016 10:11:42 GMT -6
If you buy a boring bar we can do it in my mill. I think we could figure it out. Lol Any idea where to get one and what it would cost ?
|
|
|
Post by Weezul on May 13, 2016 14:20:43 GMT -6
What axles and what is the time frame?
|
|
|
Post by mike on May 13, 2016 16:43:56 GMT -6
The one that needs honing is a dana 60. Not sure about the other one. The axles are supposed to be built except for installing the axles in the one. They are supposed to be ready to weld on the brackets and install. Time frame ? Well it's been 3 years he's been waiting so he's in no huge hurry.
|
|
|
Post by c2 on May 13, 2016 16:46:27 GMT -6
I'm down to help
|
|
|
Post by BEN on May 13, 2016 17:14:24 GMT -6
Anything for Dave.
|
|
|
Post by mike on May 13, 2016 17:47:57 GMT -6
I'll find out more details in the next few days and it will be at my place soon after.
|
|
|
Post by James on May 15, 2016 14:43:24 GMT -6
Both axles are Dana 60's
|
|
|
Post by mike on May 15, 2016 17:26:13 GMT -6
i thought so but didn't want to say until i knew for sure. Haha
|
|