|
Post by Shadrock on Jul 11, 2013 6:44:13 GMT -6
Thought you guys would get a kick out of this manifold... I call it the "Madusa Manifold". Had a nice leak, it's no wonder, it has about 19 points it could leak from. It took everything I had to keep me from fabbing 1 solid manifold and tapping it for ports. But with the A.D.D. I have, I wouldn't stop there, I'd start pulling wires, soldering, shrink wrapping, running new air tubes/wires, etc... So I traced the leak down to the air regulator, replaced it, and resealed the other joints that where loose. I guess air regulators are like TV's, you can't find one that's made in the USA. One of the ARB regulators has a small leak, so I get to rebuild it later. It's in a nice honey hole to get to also... Not too bad though.
|
|
|
Post by Somebody on Jul 11, 2013 7:19:43 GMT -6
I think I would have either bought a multiport manifold or built me one instead.. That thing is atrocious!
|
|
|
Post by Shadrock on Jul 11, 2013 7:36:56 GMT -6
I think I would have either bought a multiport manifold or built me one instead.. That thing is atrocious! No shit... That's the reason I said it took everything I had to keep me from redoing it. I'm eventually going to do some sort of highline or metalcloaks. So once I figure out where everything is going, I'll simplify the plumbing...
|
|
|
Post by jphillips on Jul 12, 2013 21:00:37 GMT -6
These are about 20 bucks from Grainger:
|
|