TJ antenna mount pattern.
Jan 21, 2014 20:50:02 GMT -6
via mobile
Somebody, mike, and 1 more like this
Post by mpdxtreme on Jan 21, 2014 20:50:02 GMT -6
If you have a TJ an want a mount for te antenna here is the pattern. It mounts the antenna on the pass side of the vehicle behind the tail light with the antenna to the right of the tail light. The bottom 2 holes are 2 inches apart so enlarge it till they are spaced 2 inches apart and you should be good.
Where the solid line is above the hole for the antenna is where it needs to be bent.
The metal this one was made from measured .15 inches. I found a table that converts measurements to gauge and it said this was 10 gauge.
My friend with the rubicon ordered this one off eBay and I traced it.
Hope this can/might help someone.
Greg G.
Where the solid line is above the hole for the antenna is where it needs to be bent.
The metal this one was made from measured .15 inches. I found a table that converts measurements to gauge and it said this was 10 gauge.
My friend with the rubicon ordered this one off eBay and I traced it.
Hope this can/might help someone.
Greg G.
Just remember...we give them back in 10 months 
It's alive!! 
