|
|
Post by jphillips on Jul 15, 2013 18:52:35 GMT -6
So after replacing my tie rod and having an alignment done, now my esc/bas light is on. I did the self diag but it seems to only show engine code because it shows nothing. I disconnected the battery to clear the lights, but that did nothing. My steering wheel has been off center by about 30 degrees for over a year with no troubles. Hopefully autozone has a scanner that will do ABS codes.
|
|
|
|
Post by N2DEEP on Jul 15, 2013 18:59:16 GMT -6
Swps need to relearn center? That's an awful lot of technology for a jeep.
|
|
|
|
Post by PARKER on Jul 16, 2013 19:57:04 GMT -6
Seems like they would have aligned your steering wheel when you got the alignment done!  |
|
|
|
Post by jphillips on Jul 16, 2013 20:12:22 GMT -6
Seems like they would have aligned your steering wheel when you got the alignment done! They did, it is straight now. I haven't been anywhere to check the ABS codes yet, maybe tomorrow. |
|
|
|
Post by jphillips on Jul 17, 2013 18:44:08 GMT -6
Well, it's fixed? Took it to Autozone and the read the code as a steering wheel angle sensor. Makes sense kinda, but then as I left the parking lot and drove about 200 hundred feet the lights went off. A couple of seconds later the traction light flashed a couple of times and went back off. Guess I will see if it stays off. |
|
Just remember...we give them back in 10 months 
It's alive!! 
