aldridgejeep
Junior Member
Well what had happened was......
Posts: 135 
|
Tranny
Aug 12, 2013 14:41:30 GMT -6
via mobile
Post by aldridgejeep on Aug 12, 2013 14:41:30 GMT -6
So I've got a cherokee, when you put it in drive it dosent want to drive. When you put it down in first it takes of great then you just shift into drive and go. The trans fluid isn't burnt smells good.....any ideas?
|
|
|
|
Tranny
Aug 12, 2013 14:47:16 GMT -6
Post by grizzlyadams on Aug 12, 2013 14:47:16 GMT -6
Check the T.V. cable(throttle valve). It is attached at the throttle body. it senses throttle position and in turn sends the correct line pressure for shifts. Mine would not shift out of second one day after wheeling. I thought I had screwed something up. Turns out the T.V. cable needed adjusting. A few minutes later all was well.
|
|
|
|
Tranny
Aug 12, 2013 15:31:21 GMT -6
Post by Somebody on Aug 12, 2013 15:31:21 GMT -6
Check the T.V. cable(throttle valve). It is attached at the throttle body. it senses throttle position and in turn sends the correct line pressure for shifts. Mine would not shift out of second one day after wheeling. I thought I had screwed something up. Turns out the T.V. cable needed adjusting. A few minutes later all was well. This.. the Catalina did the opposite.. it would shift too soon and bog down.. But if you put it in 1st and run up the gears it would shift fine.. Made my own cable and adjusted it.. shifts fine now.. |
|
aldridgejeep
Junior Member
Well what had happened was......
Posts: 135
|
Tranny
Aug 14, 2013 20:06:06 GMT -6
via mobile
Post by aldridgejeep on Aug 14, 2013 20:06:06 GMT -6
Haven't had a chance to work on this yet, but hopefully I can get it fixed in the next week and maybe go wheeling in a couple weeks...
|
|
Just remember...we give them back in 10 months 
It's alive!! 
